Skoda Octavia III 2013 Workshop Manual page 145

– Insert 2 commercially available pin bolts a few revolutions into
the holes -arrows-.
Note
Pay attention to the use by date on sealant.
– Cut off nozzle on tube at front marking (∅ of nozzle approx.
1.5 mm).
Caution
There is risk of blockage of the lubrication system through ex‐
cess sealant.
♦ Do not apply a thicker sealant bead than indicated.
– Apply sealant bead -arrow- onto the clean sealing surface of
the oil separator, as shown in the illustration.
• Thickness of sealant bead: 1.5 mm.
After applying the sealant, you must install the oil separator within
5 minutes.
– Insert oil trap onto the pin bolts -arrows- and insert onto the
cylinder block.
– Remove the pin bolts again.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
139
3. Crankcase ventilation