Skoda Octavia III 2013 Workshop Manual page 68

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Remove cylinder head
⇒ "1.3 Removing and installing cylinder head", page 69
– Remove oil sump
⇒ "1.2 Removing and installing oil sump", page 128
baffle.
– Mark installation position and assignment of the piston to the
cylinder.
– Mark the installation position and assignment of the conrod to
the cylinder and to the conrod bearing cap Pos. -4-
⇒ "4.1 Assembly overview - piston and conrod", page 59
– Remove conrod bearing cap and pull out piston with conrod
upwards.
Note
In case of tightness of the piston pin, heat piston to approximately
60 °C.
– Remove securing rings from the piston pin eye.
– Drive off piston pin with a drift - VW 222 A- .
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Replace screws which have been tightened firmly to a torque an‐
gle.
– Oil the contact surfaces of the bearing shells.
– Install piston with commercially available piston ring tension‐
ing strap, check installation position
– Install conrod bearing cap, check installation position Pos.
-2- ⇒ "4.1 Assembly overview - piston and conrod", page 59
– Install cylinder head
⇒ "1.3 Removing and installing cylinder head", page 69
– Installing the oil pan
⇒ "1.2 Removing and installing oil sump", page 128
Tightening torques
Component
Conrod with conrod bearing cap
62
Rep. gr.13 - Crankshaft group
.
, remove
.
⇒ page 60 .
.
.
Nm
30 Nm + tor‐
que a further
1
90° ( / 4 turn)
.