Removing And Installing Accelerator Module; Disconnect Connector For Accelerator Pedal Module And Fit On - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
3.2 Removing and installing accelerator
module
Removing
– Tilt the cover for underbody -1- towards the front in
-direction of arrow-.
– Disconnect plug connection -2- at the accelerator pedal mod‐
ule ⇒ page 216 .
– Unscrew screw -1-.
– Remove accelerator module -3- from the uptake.
Install
Installation is carried out in the reverse order.
Caution
There is risk of damaging the surface of the knee airbag.
After completion of assembly work with visual inspection,
check that the knee airbag surface is not damaged.
3.3 Disconnect connector for accelerator
pedal module and fit on
Note
The plugs for the accelerator pedal module which are inserted,
must be disconnected and fit on in a different manner.
Disconnect connector 1K0 973 706
– Slightly press the piston slide valve -A- (grey) in direction of
arrow -1- and push it up to the stop in direction of arrow -2-.
– Hold the piston slide valve in this position and disconnect the
socket housing -B- towards the top in direction of arrow -3-.
The piston slide valve -A- remains in the bottom position.
216
Rep. gr.20 - Fuel supply system