12 - Bolt
❑ replace after removal
❑ Tightening torque and tightening order
13 - Bolt
❑ replace after removal
❑ 60 Nm + torque a further 90° (
14 - Bolt
❑ replace after removal
❑ 60 Nm + torque a further 90° (
15 - Bolt
❑ replace after removal
❑ 50 Nm + torque a further 90° (
16 - Gearbox mount
❑ with supporting arm
❑ installing and removing
Engine support bracket - tightening torque and tightening order
Note
Replace screws which have been tightened firmly to a torque an‐
gle.
– Tighten screws in steps in the given sequence:
Stage
Screws
1st
-1 ... 3-
2nd
-1 ... 3-
3rd
-1 ... 3-
Removing and installing pendulum support
– Unscrew screw -1-.
– Remove screws -2- and -3- and remove support -4-.
Installation is carried out in the reverse order.
Note
Screws which have been tightened firmly to a torque angle must
be replaced.
– Tighten screws in steps in the given sequence:
Stage
Bolts
Tightening torque/torque angle
1st
-2-, -3-
50 Nm
2nd
-1-
130 Nm
3rd
-1 ... 3-
90° (torque a further 90° (
⇒ page 27
1
/ 4 turn)
1
/ 4 turn)
1
/ 4 turn)
⇒ "2.3 Removing and installing gearbox mount", page 28
Tightening torque/torque angle
7 Nm
40 Nm
90° (torque a further 90° (
1
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1
/ 4 turn)
/ 4 turn)
27
2. Assembly bracket