Skoda Octavia III 2013 Workshop Manual page 162

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
❑ installing and removing
⇒ "2.5 Removing and installing toothed belt pulley for coolant pump", page 162
11 - Bolt
❑ 8 Nm
12 - Bolt
❑ order of tightening
❑ 7 Nm
13 - Cover
❑ for coolant regulator
14 - Gasket
❑ replace after removal
❑ before installing, slightly moisten with coolant
15 - Thermostat
❑ For small coolant circuit
❑ Start of opening approx. 87 °C
❑ installing and removing
⇒ "2.7.1 Removing and installing thermostat for small coolant circuit", page 164
❑ Fitting position ⇒ page 156
16 - Screw
❑ Tightening torque and tightening order
Installation position of thermostat for large coolant circuit
• Must be fitted with the centring pin into guide -arrow- on cool‐
ant pump housing.
Tightening sequence thermostat housing at coolant pump - tight‐
ening torque and tightening sequence
Note
Self-cutting screws must be positioned by hand in such a way that
they find the old thread turn. Then tighten the screw to torque.
– Tighten screws in the sequence -A...F- to 8 Nm.
156
Rep. gr.19 - Cooling
⇒ page 157
⇒ page 161