Skoda Octavia III 2013 Workshop Manual page 97

• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
• On both camshafts the asymmetrically arranged grooves
-arrows- on the gearbox side must be above the middle of the
camshaft.
• On the exhaust camshaft -A-, the grooves -top arrows- are
accessible through the recesses in the coolant pump driving
wheel.
• On the inlet camshaft -E- the grooves -bottom arrow- are
above the camshaft centre.
Note
The camshafts have one symmetrically and one asymmetrically
arranged pair of grooves. In the "TDC" position the asymmetrically
arranged pair of grooves must by above the imaginary horizontal
centre line.
If the camshafts are not as described:
– Remove fixing screw - T10340- and turn crankshaft another
turn, set back to "TDC"
If the camshafts are as described:
Note
The camshaft clamp -T10494- must move into position easily.
♦
The camshaft clamp must not be positioned using any kind of
♦
hammer.
– Insert camshaft clamp -T10494- to stop into camshafts and
tighten bolt -arrow- by hand.
If camshaft clamp - T10494- cannot be installed:
Caution
To prevent damage to the belt, do not use sharp-edged tools!
⇒ page 89 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
91
2. Toothed belt drive