Skoda Octavia III 2013 Workshop Manual page 90

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Turn engine shaft further in direction of arrow so that the
screwdriver just out at the top by approx. 35 mm in the
-direction of the arrow-.
– Unscrew locking screw for "TDC" bore at the cylinder block
⇒ page 81 .
Caution
Risk of engine damage.
If the fixing screw - T10340- cannot be screwed in up to the
stop, the crankshaft is not in the correct position.
In this case, proceed as follows:
♦ Unscrew the fixing screw.
♦ Set the correct position of the crankshaft for screwing in
the fixing screw ⇒ page 83
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn crankshaft up to the stop in direction of rotation of engine.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
• On both camshafts the asymmetrically arranged grooves
-arrows- on the gearbox side must be above the middle of the
camshaft.
• On the exhaust camshaft -A-, the grooves -top arrows- are
accessible through the recesses in the coolant pump driving
wheel.
• On the inlet camshaft -E- the grooves -bottom arrow- are
above the camshaft centre.
If the camshafts are not as described:
– Remove fixing screw - T10340- and turn crankshaft another
turn, set back to "TDC"
If the camshafts are as described:
Note
The camshaft clamp - T10494- must slide into position easily.
♦
The camshaft clamp must not be positioned using any kind of
♦
hammer.
84
Rep. gr.15 - Cylinder head, valve gear
.
⇒ page 83 .