Skoda Octavia III 2013 Workshop Manual page 59

• Upper edge of sealing lip support ring -1- and front edge of
sealing flange -2- must align -arrows-.
– Lay the sealing flange -1- with the front side on the assembly
device - T10134- in such a way that the positioning pin -D-
engages into the hole -3- of the sensor rotor -2-.
• The sealing flange must lie flat on the assembly device.
– Press the sealing flange -1- and sealing lip supporting ring
-2- during tightening of 3 knurled screws -H- onto the surface
of the assembly device - T10134- to ensure that the positioning
pin is no longer able to slip out of the bore of the sensor rotor.
Note
When installing sealing flange, ensure that sender wheel remains
fixed in assembly tool.
B - Mount assembly tool - T10134- with sealing flange on crank‐
shaft flange:
• Crankshaft flange free from oil and grease.
• Engine on "TDC".
– Screw nut -B- on until it reaches end of threaded spindle.
– Press the threaded spindle on the assembly tool - T10134- in
-direction of arrow- until the nuts -B- rest against the assembly
cup -C-.
– Align flat side of assembly housing to the cylinder block sealing
surface on the oil sump side.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
2. Cylinder block, gearbox end
53