Radiator Version 3 - Summary Of Components - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
Note
The arrows which are on the coolant pipes and the coolant hose
ends must stand opposite to each other.
Connect coolant hose with quick coupling
– Remove old O-ring -2- in coolant hose -3-.
– Moisten new O-ring with coolant and insert into coolant hose.
– Press coolant hose onto connection -1- until there is an audible
click.
– Press coolant hose down again and check by pulling that the
plug-in connector is fully engaged.
4.3

Radiator version 3 - Summary of components

1 - Coolant hose
❑ to remove, raise the
holding clamps
❑ connect ⇒ page 177
2 - O-ring
❑ replace after removal
3 - Cooler for charge air circuit
❑ installing and removing
⇒ "4.6 Removing and in‐
stalling radiator",
page 179
4 - Coolant hose
❑ to remove, raise the
holding clamps
❑ connect ⇒ page 177
5 - O-ring
❑ replace after removal
6 - Coolant hose
❑ to remove, raise the
holding clamps
❑ connect ⇒ page 177
7 - O-ring
❑ replace after removal
8 - Coolant radiator
❑ installing and removing
⇒ "4.6 Removing and in‐
stalling radiator",
page 179
❑ fill with fresh coolant af‐
ter replacing
9 - Condenser
❑ removing and installing ⇒ Heating, Air Conditioning; Rep. gr. 87
10 - Top radiator bearing
❑ If the fuse latches break, you will not need to replace the top radiator bearing.
❑ The fuse is replaced by a special screw ⇒ Electronic Catalogue of Original Parts"ETKA."
176
Rep. gr.19 - Cooling