Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
4
Injectors
⇒ "4.1 Assembly overview - fuel rail with injectors", page 248
⇒ "4.2 Removing and installing the fuel distributor", page 249
⇒ "4.3 Removing and installing injectors", page 250
⇒ "4.4 Clean injection valves", page 255
4.1
Assembly overview - fuel rail with injectors
1 - Fuel pressure sender -
G247-
❑ check
⇒ "5.3 Check fuel pres‐
sure sender G247 ",
page 258
❑ installing and removing
⇒ "5.2 Removing and in‐
stalling fuel pressure
sender G247 ",
page 257
❑ Moisten the cone with
clean engine oil; the
thread must not be oiled
❑ 22 Nm
2 - Fuel distributor
❑ installing and removing
⇒ "4.2 Removing and in‐
stalling the fuel distribu‐
tor", page 249
3 - High pressure tube
WARNING
Risk of injury caused by
fuel which is under high
pressure.
♦ Before opening the high-
pressure system, the fuel
pressure must be re‐
duced to residual pres‐
sure
⇒ "3.10 Reduce pressure
in the high-pressure sys‐
tem", page 10
.
❑ replace if damaged
❑ do not change bending form
❑ installing and removing
❑ 25 Nm
4 - Bolt
❑ installing and removing
❑ 9 Nm
5 - Support ring
❑ replace after removal
❑ the fuel distributor exerts force via the support ring that holds the injector in the cylinder head
❑ connected with valve Pos. -8-
248
Rep. gr.24 - Mixture preparation - injection
⇒ "6.3 Removing and installing high pressure pipe", page 263
⇒ "4.2 Removing and installing the fuel distributor", page 249