Removing And Installing Oil Pump - Skoda Octavia III 2013 Workshop Manual

– Cut off nozzle on tube at front marking (∅ of nozzle approx.
3 mm).
– Apply sealant to clean sealing surface of sump as shown.
Sealant bead must be:
♦ 2...3 mm thick
♦ Run bead along inner side of bolt holes -arrows-
Note
The sealing compound bead must not be thicker, otherwise ex‐
cessive sealing compound will enter the sump and may block the
oil suction pipe strainer.
– Fit sump immediately and lightly tighten all sump securing
bolts ⇒ page 128 .
– Tighten the sump securing bolts to the prescribed torque.
Tightening torque of gearbox screws: ⇒ Gearbox; Rep. gr. 34 .
Note
Let sealing compound dry for approx. 30 minutes after installing
oil sump. Only then fill with engine oil.
– Install oil filter and tighten it with the oil filter wrench - 3417- .
– Fill engine oil ⇒ Maintenance ; Booklet Octavia III .
– Install AC compressor ⇒ Heating, Air Conditioning; Rep. gr.
87 .
Install the V-ribbed belt
⇒ "1.2 Removing and installing poly V-belt", page 37
Further installation occurs in a similar way in reverse order to re‐
moval.
Tightening torques
Component
Oil filter
Oil sump screws
1.3

Removing and installing oil pump

Removing
– Disconnect battery ⇒ Electrical System; Rep. gr. 27 .
– Remove toothed belt
⇒ "2.5 Removing and installing toothed belt", page 99
– Removing the oil pan
⇒ "1.2 Removing and installing oil sump", page 128
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
.
Nm
20 Nm
⇒ page 128
.
.
131
1. Lubrication system