Removing And Installing Injectors - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Separate electrical plug connection -1-.
Note
Place a cloth below to absorb leaking fuel.
– Release the screws -arrows- and disconnect the fuel distribu‐
tor from the injection valves.
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Renew O-ring.
– Position fuel distributor on the injectors.
– Press fuel distributor first to the right, then to the left onto the
injectors up to the stop.
– Press fuel distributor down firmly in the holder area and tighten
screws by 2 turns.
– Tighten screws crosswise uniformly.
– Install high pressure pipe
⇒ "6.3 Removing and installing high pressure pipe",
page 263 .
– Installing the intake manifold
⇒ "3.2 Removing and installing intake manifold", page 241
Tightening torques
Component
Fuel distributor screw
♦ ⇒ "4.1 Assembly overview - fuel rail with injectors", page 248
4.3

Removing and installing injectors

Special tools and workshop equipment required
♦ Pulling device - T10133- with removal tool - T10133/16A- and
extractor - T10133/19-
Removing
Caution
There is a risk of malfunctions caused by soiling.
♦ ⇒ "3.1 Rules of cleanliness", page 7
Note
Injectors must not be removed while the engine is cold.
– Removing the intake manifold
⇒ "3.2 Removing and installing intake manifold", page 241
250
Rep. gr.24 - Mixture preparation - injection
.
Nm
9 Nm
.