Skoda Octavia III 2013 Workshop Manual page 38

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Connect supporting device - T30099- as shown in the illustra‐
tion.
– Attach snap hook to the engine suspension eyes.
– Slightly pre-tension engine/gearbox unit with the spindles, do
not raise.
– Unscrew screws -arrows- for engine mount one after another
and replace (if not already done during engine installation).
– Loosely insert the screws.
– Unscrew screws -arrows- for gearbox mount -1- after another
and replace (if not already done during engine installation).
– Loosely insert the screws.
– Move engine/gearbox unit with an assembly lever until the fol‐
lowing dimensions are set:
A distance of -a- = 10 mm must be present between engine sup‐
port -2- and engine mount -1-.
The cast edge on the engine support -2- must be parallel with the
engine mount supporting arm -1-.
Dimension -b- = dimension -b-.
Note
The distance -a- = 10 mm can be checked, for example with suit‐
able round bars.
– Tighten engine mount screws.
32
Rep. gr.10 - Removing and installing engine