Removing And Installing Thermostat - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
Removing
– Open cap -arrow- for coolant expansion tank.
WARNING
There is risk of injury due to hot steam and hot coolant.
♦ When the engine is warm, the cooling system is under
overpressure.
♦ Reduce excess pressure by covering the cap of the cool‐
ant expansion tank with a cloth and opening it carefully.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 66 .
– Separate electrical plug connection -1-.
– Place a catch pan for workshop crane - VAS 6208- under‐
neath.
– At the charge air cooler pump - V188- disconnect coolant ho‐
ses with hose clamps -3094- .
– Loosen hose clamps -3- and remove coolant hoses.
– Undo screw -2- and remove charge air cooler pump - V188- .
Installing
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
Note
Secure all hose connections with hose clamps which comply with
the series design ⇒ Electronic Catalogue of Original Parts"ET‐
KA." .
– Install the noise insulation ⇒ Body Work; Rep. gr. 66 .
– Check coolant level ⇒ page 151
Tightening torque
Component
Screw for pump
2.7

Removing and installing thermostat

⇒ "2.7.1 Removing and installing thermostat for small coolant cir‐
cuit", page 164
⇒ "2.7.2 Removing and installing thermostat for large coolant cir‐
cuit", page 167
2.7.1 Removing and installing thermostat for
small coolant circuit
Special tools and workshop equipment required
♦ Pliers for spring strap clamps
♦ Key - T10508-
♦ Release tool - T10527-
164
Rep. gr.19 - Cooling
.
Nm
8 Nm