Removing And Installing Oil Filter Housing - Skoda Octavia III 2013 Workshop Manual

Note
Mechanical damage such as bearing damage may also be the
cause of oil pressure that is too low.
If no fault is found:
– Replace oil pump
⇒ "1.3 Removing and installing oil pump", page 131
Check oil pressure switch for reduced oil pressure - F378- :
– Switch off engine.
– Connect brown wire of oil testing device - V.A.G 1342- to earth
(-).
– Connect the voltage tester - V.A.G 1527 B- with adapter set
from measuring tool set - V.A.G 1594 C- to the battery positive
pole (+) and connect oil pressure switch for reduced oil pres‐
sure - F378- (brown).
• The LED must not light up.
– If the LED is illuminated the oil pressure switch for reduced oil
pressure - F378- must be replaced.
If the LED does not light up:
– Start engine, at an overpressure of 0.03 .... 0.06 MPa
(0.3...0.6 bar) the LED must light up, otherwise renew oil pres‐
sure switch
⇒ "4.2 Removing and installing oil pressure switch for reduced
oil pressure F378 ", page 141
4.4

Removing and installing oil filter housing

Special tools and workshop equipment required
♦ Oil filter tool - 3417-
Removing
– Drain engine oil ⇒ Maintenance ; Booklet Octavia III .
– Remove oil filter -arrow- with oil filter tool - 3417- .
Install
– Fill oil filter with engine oil and moisten the gasket with oil.
– Tighten the oil filter using the oil filter tool - 3417- , tightening
torque 20 Nm.
– Fill engine oil ⇒ Maintenance ; Booklet Octavia III .
1.2/63; 77 kW TSI engine - Edition 11.2014
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
4. Oil filter, oil pressure switch
143