Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Turn engine shaft further in direction of arrow so that the
screwdriver just out at the top by approx. 35 mm in the
-direction of the arrow-.
– Unscrew locking screw for "TDC" bore at the cylinder block
⇒ page 81
.
Caution
Risk of engine damage.
If the fixing screw - T10340- cannot be screwed in up to the
stop, the crankshaft is not in the correct position.
In this case, proceed as follows:
♦ Unscrew the fixing screw.
♦ Set the correct position of the crankshaft for screwing in
the fixing screw
⇒ page 89
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn crankshaft up to the stop in direction of rotation of engine.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
90
Rep. gr.15 - Cylinder head, valve gear
.