Skoda Octavia III 2013 Workshop Manual page 215

– Disconnect plug connection -1- at the closing flange.
– Connect remote control - V.A.G 1348/3A- with adapter line -
V.A.G 1348/3-3- and with the line from the measuring tool set
- V.A.G 1594/C- to contact -1-.
– Mask second plug contact of the adapter - V.A.G 1348/3-3-
with short-circuit proof tape -arrow-.
– Connect contact -5- with line of auxiliary measuring set - V.A.G
1594/C- to body mass -A-.
– Connect alligator clip to the positive terminal "+" -B-.
Note
Primary pressure must be built up against which the fuel pump
must work when the fuel delivery flow in the fuel line is being
measured. This primary pressure is set as follows using pressure
gauge VAS 6550:
– Operate remote control - V.A.G 1348/3A- . While doing this,
slowly close the shut-off tap -B- until the pressure gauge dis‐
plays a pressure of 0.4 MPa (4 bar). From this point on do not
move position of shut-off tap.
– Empty measuring glass.
– Activate remote control for 15 seconds.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Fuel tank and fuel delivery unit
209