Skoda Octavia III 2013 Workshop Manual page 178

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Using the screwdriver in the direction of arrow -2- carefully
press and at the same time raise the coolant pipe -4- in direc‐
tion of arrow -3- until it is released from the locking mechanism.
– Remove the coolant pipe -1- in -direction of arrow- upwards,
and release it from the locking mechanism -2-.
Installing
– Press the coolant pipe onto the bearings -1- and -2- until it
latches.
– By pulling in the opposite direction, check that both bearings
are locked.
Note
♦ Replace gaskets and O-rings.
Secure all hose connection ends with spring-type clips that
♦
comply with the series design ⇒ ETKA - Electronic Catalogue
of Original Parts .
Installation is carried out in the reverse order. When installing,
note the following:
– Check coolant level ⇒ page 151
Tightening torques
♦ ⇒ "3.1 Assembly overview - intake manifold", page 240
172
Rep. gr.19 - Cooling
.