Skoda Octavia III 2013 Workshop Manual page 56

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Turn engine shaft further in direction of arrow so that the
screwdriver just out at the top by approx. 35 mm in the
-direction of the arrow-.
– Unscrew locking screw for "TDC" bore at the cylinder block
⇒ page 81 .
Caution
Risk of engine damage.
If the fixing screw - T10340- cannot be screwed in up to the
stop, the crankshaft is not in the correct position.
In this case, proceed as follows:
♦ Unscrew the fixing screw.
♦ Set the correct position of the crankshaft for screwing in
the fixing screw ⇒ page 49
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn crankshaft up to the stop in direction of rotation of engine.
• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
– Removing the oil pan
⇒ "1.2 Removing and installing oil sump", page 128
– Remove the engine speed sender - G28- -arrow-
⇒ "1.5 Removing and installing engine speed sender G28 ",
page 284 .
– Unscrew screws -arrows- on sealing flange -1-.
50
Rep. gr.13 - Crankshaft group
.
.