Skoda Octavia III 2013 Workshop Manual page 61

E - Inspect the installation position of the rotor on the crankshaft
– Screw nut -B- on until it reaches end of threaded spindle.
– Unscrew both bolts-2- from the cylinder block.
– Unscrew knurled screws -H- from the sealing flange -1-.
– Unscrew assembly device - T10134- from the crankshaft
flange - to do so, unscrew the hexagon socket head bolts -E-
from the crankshaft flange.
– Remove sealing lip support ring.
– Mount depth gauge - VAS 6082- onto the crankshaft flange
-2-.
– Measure distance -a- between crankshaft flange -2- and sen‐
sor rotor -1-.
• Specified value: Dimension -a- = 0.5 mm.
– If the specified value is too small, press rotor down
⇒ page 55 .
– When the specified value has been reached, perform the re‐
maining assembly ⇒ page 56
F - Pressing down the rotor:
– Screw assembly tool - T10134- with Allan screws -E- up to the
stop onto the crankshaft flange.
– Screw three knurled screws -H- into the sealing flange -1-.
– Screw nuts -B- onto threaded spindle by hand until it lies
against assembly device - T10134- .
1.2/63; 77 kW TSI engine - Edition 11.2014
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Cylinder block, gearbox end
55