Skoda Octavia III 2013 Workshop Manual page 42

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1.1.2 Summary of components - Vehicles with air conditioning
1 - Poly V-belt
❑ check for wear
❑ mark the direction of ro‐
tation with chalk or a felt-
tip pen before removing
❑ do not kink
❑ Routing of the ribbed V-
belt ⇒ page 39
❑ installing and removing
⇒ "1.2.1 Removing and
installing V-ribbed belt -
Vehicles without air con‐
ditioning ", page 37
❑ pay attention to the cor‐
rect position on the belt
pulley when installing it
2 - Bolt
❑ replace after removal
❑ to release and tighten
use counterholder -
T10475-
Caution
There is a risk of destruc‐
tion of the engine.
♦ So as not to adjust the
timing the crankshaft
must not be turned while
the screws are removed.
❑ 150 Nm + torque a fur‐
1
ther 180° ( / 2 turn)
3 - Crankshaft-belt pulley
❑ with vibration damper
❑ installing and removing
Caution
There is a risk of destruc‐
tion of the engine.
♦ So as not to adjust the
timing the crankshaft
must not be turned while
the vibration damper is
removed.
4 - Tensioning device for V-ribbed belt
❑ Swivel tensioning device for V-ribbed belt with socket insert to slacken the V-ribbed belt
❑ lock with locking pin - T10060 A-
❑ installing and removing
5 - Bolt
❑ 20 Nm + torque a further 90° (
6 - Bolt
❑ 23 Nm
36
Rep. gr.13 - Crankshaft group
⇒ "1.4 Removing and installing ribbed belt pulley", page 40
⇒ "1.3 Removing and installing tensioning device for V-ribbed belt", page 39
1
/ 4 turn)