Installing Engine - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Secure engine with bolts -arrows- at engine and gearbox
mount - VAS 6095- as shown in the illustration.
1.3

Installing engine

Work procedure
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
– Installing intermediate plate
For vehicles with manual gearbox
– Clean the serration of the drive shaft and if the clutch disc has
been used clean the hub serration, remove any corrosion
present and only apply a very thin layer of grease - G 000 100-
to the serration of the drive shaft.
– Subsequently move the clutch disc up and down on the drive
shaft until the hub fits smoothly on the shaft. Always remove
excess grease.
– Check the centering of the clutch disc ⇒ Gearbox; Rep. gr.
30 .
– Check the clutch release bearing for wear. Replace release
bearing if worn ⇒ Gearbox; Rep. gr. 30 .
22
Rep. gr.10 - Removing and installing engine
⇒ page 48 .