Skoda Octavia III 2013 Workshop Manual page 41

3 - Poly V-belt
❑ check for wear
❑ mark the direction of rotation with chalk or a felt-tip pen before removing
❑ do not kink
❑ Routing of the ribbed V-belt
❑ installing and removing
❑ pay attention to the correct position on the belt pulley when installing it
4 - Bolt
❑ replace after removal
❑ 20 Nm + torque a further 90° (
5 - Tensioning device for V-ribbed belt
❑ Swivel tensioning device for V-ribbed belt with socket insert to slacken the V-ribbed belt
❑ lock with locking pin - T10060 A-
❑ installing and removing
6 - Bolt
❑ 23 Nm
7 - AC generator
❑ removing and installing ⇒ Electrical System; Rep. gr. 27
❑ depending on the model of the alternator, different separation V-ribbed belt pulleys can be fitted with
freewheel -A- and -B-
❑ depending on the model of the belt pulley for alternator, the correct length of the V-ribbed belt must be
assigned ⇒ ETKA - Electronic Catalogue of Original Parts
Model of the V-ribbed belt pulley with freewheel
⇒ page 38
⇒ "1.2 Removing and installing poly V-belt", page 37
1
/ 4 turn)
⇒ "1.3 Removing and installing tensioning device for V-ribbed belt", page 39
⇒ page 35
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Cylinder block (pulley end)
35