Skoda Octavia III 2013 Workshop Manual page 279

❑ Do not damage wire mesh on decoupling element
❑ protect catalytic converter against shocks and blows
❑ installing and removing
⇒ "1.3 Removing and installing catalytic converter with pre-exhaust pipe", page 275
❑ Remove the protection for the decoupling element on the spare part as late as possible
❑ Align exhaust system free of stress
11 - Screw clamp
❑ Tightening torque and tightening order
12 - Gasket
❑ replace after removal
13 - Exhaust gas turbocharger
❑ installing and removing
❑ Tightening torque and tightening order
⇒ "1.1 Summary of components - exhaust gas turbocharger ", page 221
14 - Nut
❑ 30 Nm
15 - Clamping sleeve
❑ before tightening, align exhaust system free of stress
⇒ "1.5 Aligning exhaust system free of stress", page 279
❑ Fitting position ⇒ page 273
❑ Tighten screwed connections uniformly
Installation position of front clamp
– Install clamping sleeve in the position shown.
• Angle -α- = approximately 20°.
• Bolted connection to the right.
• Nuts upwards.
⇒ "1.5 Aligning exhaust system free of stress", page 279
⇒ page 277
⇒ "1.2 Removing and installing exhaust gas turbocharger", page 223
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
1. Removing and installing exhaust system
273