Stopping The Machine; Adjusting The Height Of Cut - Toro 74945 Operator's Manual

Figure 26

Stopping the Machine

To stop the machine, move the traction-control levers
to neutral, and then move them to the locked position,
disengage the blade-control switch (PTO), and turn
the ignition key to the O
Engage the parking brake when you leave the
machine; refer to Engaging the Parking Brake (page
21). Remember to remove the key from the ignition
switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
position.
FF

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
U position for the transport position
NLOCK
g008953
1. Transport lock
2. L position—mower
OCK
deck locks into transport
position
26
position and a
OCK
Figure 27
Transport-Lock Positions
3. U
NLOCK
not lock the mower deck
into transport position
(Figure 27).
g032377
position—does