Engine Maintenance; Servicing The Air Cleaner - Toro Z Master Professional 6000 Series Operator's Manual

Hide thumbs Also See for Z Master Professional 6000 Series:
Table of Contents

Advertisement

12.
Insert the second bearing and new seal into the
wheel.
13.
Apply a thread-locking compound to the second
spacer nut and thread it onto the axle with the
wrench flats facing outward.
14.
Torque the nut to 8 to 9 N∙m (75 to 80 in-lb),
loosen the nut, then torque it to 2 to 3 N∙m (20
to 25 in-lb).
Note:
Make sure that the axle does not extend
beyond either nut.
15.
Install the seal guards over the wheel hub and
insert wheel into the caster fork.
16.
Install the caster bolt and tighten the nut fully.
Important:
To prevent seal and bearing damage,
check the bearing adjustment often. Spin the
caster tire. The tire should not spin freely (more
than 1 or 2 revolutions) or have any side play. If
the wheel spins freely, adjust the torque on the
spacer nut until there is a slight amount of drag.
Apply another layer of thread-locking compound.

Engine Maintenance

WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other
body parts away the muffler and other hot
surfaces.

Servicing the Air Cleaner

Every 250 hours—Replace the primary air filter
(more often in dusty or sandy conditions).
Every 250 hours—Check the safety air filter.
Every 500 hours—Replace the safety air filter.
Note:
Check the filters more frequently if the
operating conditions are extremely dusty or sandy.
Removing the Filters
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(Figure
49).
1. Air-cleaner body
2. Primary filter
3. Latch
4.
Clean the inside of the air-cleaner cover with
compressed air.
5.
Gently slide the primary filter out of the
air-cleaner body
40
EUTRAL
Figure 49
4. Air-cleaner cover
5. Safety filter
(Figure
49).
-
LOCK
g032301

Advertisement

Table of Contents
loading

This manual is also suitable for:

74902te

Table of Contents