Servicing The Caster Wheel And Bearings; Adjusting The Electric Clutch - Toro 30327 Operator's Manual

Figure 43
1. Mounting Tube
5. Grease the inside and outside of the new
bushings. Use a hammer and flat plate to
carefully drive the bushings into the mounting
tube.
6. Inspect the caster wheel fork for wear and
replace if necessary (Figure 42).
7. Slide the caster wheel fork through the
bushings in the mounting tube. Replace the
spacer(s) onto the fork and secure with the
retaining ring (Figure 42).
Important: The inside diameter of
the bushings may collapse slightly when
installed. If the caster wheel fork does not
slide into the new bushings, ream both
bushings to an inside diameter of 1.126
inch (29 mm).
8. Grease the fitting on the carrier frame
mounting tube using No. 2 general purpose
lithium base or molybdenum base grease.
Servicing the Caster Wheel
and Bearings
The caster wheels rotate on a roller bearing
supported by a spanner bushing. If the bearing is
kept well lubricated, wear will be minimal. Failure
to keep the bearing well lubricated will cause rapid
wear. A wobbly caster wheel usually indicates a
worn bearing.
1. Remove the locknut and wheel bolt holding
the caster wheel to the caster fork (Figure 44).
2. Bushing
Figure 44
1. Locknut
2. Wheel Bolt
3. Bushing
2. Remove one bushing, then pull the spanner
bushing and roller bearing out of the wheel
hub (Figure 44).
3. Remove the other bushing from the wheel hub
and clean any grease and dirt from the wheel
hub (Figure 44).
4. Inspect the roller bearing, bushings, spanner
bushing and inside of the wheel hub for
wear. Replace any defective or worn parts
(Figure 44).
5. To assemble, place one bushing into the wheel
hub. Grease the roller bearing and spanner
bushing and slide them into the wheel hub.
Place the second bushing into the wheel hub
(Figure 44).
6. Install the caster wheel into the caster fork
and secure with the wheel bolt and locknut.
Tighten the locknut until the spanner bushing
bottoms against the inside of the caster forks
(Figure 44).
7. Grease the fitting on the caster wheel.

Adjusting the Electric Clutch

The clutch is adjustable to ensure proper
engagement and proper braking. Check
adjustment after every 100 hours of operation.
1. To adjust the clutch, tighten or loosen the lock
nuts on the flange studs (Figure 45).
35
4. Spanner Bushing
5. Roller Bearing