Drive System Maintenance; Adjusting The Traction Pedal Angle; Changing The Planetary Gear Drive Oil - Toro Groundsmaster 4010 Operator's Manual

Drive System
Maintenance
Adjusting the Traction
Pedal Angle
The traction pedal operating angle can be adjusted
for operator comfort.
1. Loosen the 2 nuts and bolts securing the left side
of the traction pedal to the bracket
Figure 87
1. Traction pedal
2. Pivot the pedal to the desired operating angle
and tighten the nuts
Changing the Planetary
Gear Drive Oil
Service Interval: After the first 200 hours
Every 800 hours (Or yearly, whichever comes
first)
Change the oil initially after first 200 hours of
operation. Thereafter change the oil every 800 hours,
or yearly, whichever occurs first. Use a high quality
SAE 85W-140 gear lube.
1. With the machine on a level surface, position a
wheel so that one of the check plugs is at the
lowest (6 o'clock) position
(Figure 87).
2. Mounting nuts and bolts
(2)
(Figure 87)˙.
(Figure 88).
1. Check/drain plug
2. Place a drain pan under the planetary hub,
remove plug and allow oil to drain.
3. Place a drain pan under the brake housing,
remove the drain plug and allow the oil to drain
(Figure 89).
g009745
1. Drain plug
4. When all of the oil has drained from both
locations, re-install the plug in the brake
housing.
5. Rotate the wheel until the open plug hole in the
planetary is at the twelve o'clock position.
6. Through the open hole, slowly fill the planetary
with 0.65 L (22 oz) of high quality SAE 85W-140
wt gear lube.
Important:
0.65 L (22 oz) of oil is added, wait one hour
or install the plug and move the machine
approximately ten feet to distribute the oil
through the brake system. Then, remove the
plug and add the remaining oil.
7. Install the plug.
8. Repeat the procedure on the opposite
planetary/brake assembly.
61
Figure 88
Figure 89
2. Brake housing
If the planetary fills before the
g008862
g020680