Checking The Rear-Wheel Toe-In - Toro Groundsmaster 5910 Operator's Manual

Figure 74
1. Drain plug
4. When all of the oil has drained from both locations,
install the plug in the brake housing.
5. Rotate the wheel until the open holes in the planetary
are at the 11 o'clock and 1 o'clock positions.
1
Figure 75
1. Holes at the 11 o'clock and 1 o'clock positions
6. Through either open hole, slowly fill the planetary with
0.53 to 0.59 L (18 to 20 ounces) of high quality SAE
85W-140 wt. gear lube.
7. Install the plugs.
8. Repeat the procedure on the opposite planetary/brake
assembly
g021 156
2. Brake housing
G024858
Checking the Rear-Wheel
Toe-in
Service Interval: Every 1,000 hours—Check the rear-wheel
toe-in.
1. Measure the center-to-center distance (at axle height) at
the front and rear of the steering tires
Note: The front measurement cannot be more than 3
mm (0.12 inch) less than the rear measurement.
1. Center-to-center distance
2. To adjust, loosen the clamps at both ends of the tie
rods (Figure 76).
3. Rotate the tie-rod end to move the front of the tire
inward or outward.
4. Tighten the tie-rod clamps when the adjustment is
correct.
51
(Figure
Figure 76
2. Tie-rod clamps
76).