Rear Wheel Motors (Machines With Optional Crosstrax Tm Kit) - Toro Reelmaster 5010- H Service Manual

Rear Wheel Motors (Machines with Optional CrossTrax
6
8
7
13
RIGHT
FRONT
1. Lug nut (5 used per wheel)
2. Rear wheel assembly
3. Wheel hub assembly
4. Lock nut
5. Woodruff key
Removal (Fig. 67)
1. Park the machine on a level surface, lower the cut-
ting units and stop the engine. Remove the key from the
ignition switch.
2. Chock rear wheels to prevent machine from moving
or shifting.
3. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Hydraulic System
14
70 to 80 ft- lb
(95 to 108 N- m)
Figure 67
o
6. 45 hydraulic fitting (2 per motor)
7. O- ring
8. O- ring
9. Hydraulic hose (4 used)
10. Cap screw (4 per motor)
Page 4 - 78
TM
Kit)
12
7
5
11
10
270 to 330 ft- lb
(367 to 447 N- m)
11. Lock washer (4 per motor)
12. LH rear wheel motor
13. RH rear wheel motor
14. CrossTrax
4. Loosen, but do not remove, lock nut (item 4) from
rear wheel motor shaft.
5. Remove rear wheel from machine (see Wheels in
the Service and Repairs section of Chapter 6 - Chas-
sis).
9
6
8
3
4
70 to 90 ft- lb
(95 to 122 N- m)
TM
control manifold
Reelmaster 5010- H
2
1