Oracle SPARC M8 Service Manual page 127

4. Determine your next step based on your server Oracle ILOM version.
SPARC M7 servers running Oracle ILOM version 4.0.x do not require you to prepare the SPM
for removal. SPARC M8-8 servers ship with a minimum Oracle ILOM version of 4.0.x.
Always update your system firmware to latest available and supported version for
Note -
optimal performance, security, and stability.
For servers running Oracle ILOM version 4.0.x, or a future supported
■
version, go to
For servers running Oracle ILOM version 3.2.x, continue to
■
(Oracle ILOM 3.2.x only) Prepare the SPM for removal.
5.
If your server is running Oracle ILOM version 4.0.x, or a future compatible version, do
Note -
not perform this step.
-> cd /System/Other_Removable_Devices/Service_Processors/
Service_Processor_x/Service_Processor_Module_0
-> set action=prepare_to_remove
This command can take several minutes to complete.
Determine your next step:
For SPARC M8-8 and SPARC M7-8 servers with two PDomains, perform this step for the
■
second SPM, and then go to
For SPARC M8-8 and SPARC M7-8 servers with one PDomain, go to
■
For SPARC M7-16 servers, go to
■
6. For SPARC M8-8 and SPARC M7-8 servers only, verify that the PCIe devices are
offline.
For SPARC M8-8 and SPARC M7-8 servers with two PDomains, check the
■
state for both SPMs.
-> show /System/Other_Removable_Devices/Service_Processors/
Service_Processor_x/Service_Processor_Module_0 state_pcie
Properties:
state_pcie = Offline
-> show /System/Other_Removable_Devices/Service_Processors/
Service_Processor_x/Service_Processor_Module_1 state_pcie
Properties:
state_pcie = Offline
Step 6.
Step 6.
Step 7.
Prepare to Remove an SP
Step 5.
Step 6.
Servicing SPs 127