Identify Disabled Components - Oracle SPARC M8 Service Manual

Identify Disabled Components

Message identifier (SPT-8000-5X), which can be used to obtain additional fault information
■
from Knowledge Base articles.
2. Use the message ID to obtain more information about this type of fault.
Obtain the message ID from console output.
a.
b. Go to https://support.oracle.com, and search on the message ID in the
Knowledge tab, or copy the URL in the Action field into a browser.
Follow the suggested actions to repair the fault.
3.
If you found a fault that must be removed manually, go to
4.
Manually" on page
Related Information
"Log In to Oracle ILOM (Service)" on page 67
■
"Clear a Fault Manually" on page 55
■
"Component Names Displayed by Diagnostic Software" on page 40
■
Identify Disabled Components
You can run the show disabled command from the Oracle ILOM prompt to identify
components that have been disabled either intentionally, by a user, or because of a fault.
1. To identify disabled components, at the Oracle ILOM prompt type:
-> show disabled
Target
-----------------------------------+----------------+--------------------
...
/SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM | disable_reason | Configuration Rules
...
2.
For additional information about a disabled component, type the show - t
command and the Oracle ILOM target name:
-> show -t /SYS/CMIOU0/CM/CMP/BOB31/CH0/DIMM
Target
-----------------------------------+------------------------+------------
...
38 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
55.
| Property
| Property
"Clear a Fault
| Value
| Value