Clear A Fault Manually - Oracle SPARC M8 Service Manual

See "Interpreting LEDs" on page
Log in to Oracle ILOM.
2.
See "Log In to Oracle ILOM (Service)" on page
3. Verify that the server is operating normally.
At the Oracle ILOM prompt, type:
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp> fmadm faulty
Determine your next step.
4.
If a fault was detected using the fmadm faulty command, see
■
Manually" on page
If no fault was detected, the component was installed successfully.
■
Related Information
"Identify Faulted Components" on page 36
■
"Clear a Fault Manually" on page 55
■

Clear a Fault Manually

When the server detects faults, the faults are logged and displayed on the console. In most
cases, after the fault is repaired, the corrected state is detected by the server, and the fault
condition is repaired automatically. In cases where the fault condition is not automatically
cleared, you must clear the fault manually.
1. After replacing a faulty component, power on the server, and verify that the fault
for that component has cleared.
See "Verify That a Fault Has Been Cleared" on page
2. Determine your next step.
If no fault was detected, you do not need to do anything else. Do not perform the subsequent
■
steps.
If a fault was detected, continue to the next step.
■
3. Clear the fault from all persistent fault records.
44.
55.
67.
"Clear a Fault
54.
Detecting and Managing Faults
Clear a Fault Manually
55