Oracle SPARC M8 Service Manual page 244

Unseat or Remove an SP Tray
See "Prevent ESD Damage" on page
Locate the SP tray in the server.
2.
See "CMIOU Chassis Rear Components" on page 21
(SPARC M7-16)" on page
3. Power off the server and switch off the appropriate PDU circuit breakers.
See "Removing Power From the Server or Domain" on page
4. Label and disconnect the cables attached to the NET MGT and SER MGT ports.
See "CMIOU Chassis Rear Components" on page
(SPARC M7-16)" on page
Numbering" on page
Remove the SPs to gain access to the SP tray ejector locking latches.
5.
See "Servicing SPs" on page
Press the ejector latches to release the SP tray.
6.
Using a flat-blade screwdriver, press up on the small metal latch inside the recess of the tray to
release the tray from the chassis. Repeat this step for the second latch.
244 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
61.
25.
25, and "SER MGT and NET MGT Port Locations and
121.
117.
or "Switch Chassis Rear Components
69.
21, "Switch Chassis Rear Components