Restart The Server Or Host (Oracle Ilom) - Oracle SPARC M8 Service Manual

Restart the Server or Host (Oracle ILOM)

Related Information
"Restart the Server or Host (Oracle ILOM)" on page 74
■
"Servicing PDUs" on page 253
■
Restart the Server or Host (Oracle ILOM)
Log in to Oracle ILOM.
1.
See "Log In to Oracle ILOM (Service)" on page
2. Connect to the host console.
Before starting the server or a specific host, connect to the host console in a separate terminal
session to ensure that you can view all messages reported by the system.
At the Oracle ILOM prompt, type:
-> start /Servers/PDomains/PDomain_x/HOST/console
Are you sure you want to start
/Servers/PDomains/PDomain_x/HOST/console (y/n) ? y
Starting /Servers/PDomains/PDomain_x/HOST/console
Power on the server or a specific domain.
3.
To power on all domains, at the Oracle ILOM prompt, type:
■
-> start /System
Note -
start /System command. The server will return a message that the target is already started.
To power on a specific domain, at the Oracle ILOM prompt, type:
■
-> start /Servers/PDomains/PDomain_x/HOST
4. If you are restarting the host following the replacement of a faulty component,
verify that the fault has been resolved.
See "Verify That a Fault Has Been Cleared" on page
Related Information
"Log In to Oracle ILOM (Service)" on page 67
■
"Switch on PDU Circuit Breakers" on page 73
■
74 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
On multidomain servers, if one of the hosts is already running, you cannot use the
67.
54.