Filler Panels And Modules; Component Service Categories - Oracle SPARC M8 Service Manual

Related Information
"Component Service Categories" on page 59
■
"Prevent ESD Damage" on page 61
■

Filler Panels and Modules

Depending on the configuration, the server can include the following items:
CMIOU fillers are present in configurations that have fewer than the maximum number of
■
CMIOUs installed. A CMIOU filler does not need to be installed in an empty slot during a
CMIOU service procedure.
Port plugs are installed in the serial and network ports on an SP or SPP that are not used by
■
your system's configuration. These port plugs must be transferred from an SP or SPP during
the replacement of these components.
No filler panels are required for the PCIe slots as long as the PCIe card carrier is installed.
■
Caution -
server unless you remove one to install a functioning component at the same time.
Related Information
"Safety Information" on page 57
■
"Component Service Categories" on page 59
■

Component Service Categories

The following table identifies the replaceable server components.
Component
Battery
Chassis
To maintain the proper air flow, all filler panels and modules must remain in the
A/C Power Status
for Removal
On
Off
Authorized Remove and Replace Instructions
Service
Personnel Only
X "Servicing Batteries" on page 247
X "Servicing the CMIOU
Chassis" on page 269
Filler Panels and Modules
Preparing for Service 59