Oracle SPARC M8 Service Manual page 130

Prepare to Remove an SPP (SPARC M7-16)
2. Ensure that the SPMs on the SPP that you are removing are not managing
hardware.
This example shows how to check the state of both SPMs on SPP2. See
for SPMs" on page
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_0 state_sp
Properties:
state_sp = OffDuty
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_1 state_sp
Properties:
state_sp = OffDuty
If the state reports OffDuty, neither of the SPMs on SPP2 are managing a DCU. Move to
4.
If the state reports Running, you must change the DCU PDomain assignment. For example, if
you want to remove SPP2 and it is currently running, you need to ensure that DCU2 is managed
by /SYS/SPP3/SPM0 and that DCU3 is managed by /SYS/SPP3/SPM1. See
Is Managing DCU Activity (SPARC M7-16)" on page
3. Determine your next step based on your server Oracle ILOM version.
SPARC M8-8 and SPARC M7 servers running Oracle ILOM version 4.0.x do not require you to
prepare the SPM for removal or verify that the SPMs and PCIe devices are offline.
Note -
optimal performance, security, and stability.
For servers running Oracle ILOM version 4.0.x, or a future supported
■
version, go to
For servers running Oracle ILOM version 3.2.x, continue to
■
(Oracle ILOM 3.2.x only) Prepare each SPM for removal.
4.
-> set /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_0
action=prepare_to_remove
-> set /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_1
action=prepare_to_remove
130 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
122.
Always update your system firmware to latest available and supported version for
Step 6.
"Oracle ILOM Paths
"Change Which SPP
125.
Step
Step
7.