Safety Symbols; Tools Needed For Service - Oracle SPARC M8 Service Manual

Tools Needed for Service

Remove power from the server before servicing any of the components that are inside the
■
chassis.
Ensure that the voltage and frequency of your power source match the voltage and
■
frequency inscribed on the equipment's electrical rating label.
Follow the ESD safety practices as described in
■

Safety Symbols

Note the meanings of the following symbols that might appear in this document:
Caution -
equipment damage, follow the instructions.
Caution -
touched.
Caution -
personal health, follow the instructions.
Related Information
"Removing Power From the Server or Domain" on page 69
■
"Tools Needed for Service" on page 58
■
Tools Needed for Service
You will need the following tools for most service operations:
Antistatic wrist strap
■
Grounded antistatic mat large enough for the component to be serviced
■
No. 2 Phillips and flathead screwdrivers
■
T8, T10, T20, and T25 Torx wrench key, wrench, or driver
■
Mechanical lift (for some service procedures if only one person is present)
■
58 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
There is a risk of personal injury or equipment damage. To avoid personal injury and
Hot surface. Avoid contact. Surfaces are hot and might cause personal injury if
Hazardous voltages are present. To reduce the risk of electric shock and danger to
"Prevent ESD Damage" on page 61.