Verify That A Fault Has Been Cleared - Oracle SPARC M8 Service Manual

Verify That a Fault Has Been Cleared

Commands:
->
Caution -
testing of the server. For some configurations, setting the verbosity values to none will prevent
POST output from displaying on the console for an extended period of time.
Related Information
"POST Overview" on page 52
■
"Oracle ILOM Properties That Affect POST Behavior" on page 54
■
Oracle ILOM Properties That Affect POST Behavior
There are a number of Oracle ILOM commands that you can use to perform host diagnostic
tests. For details about using these commands, refer to the chapter that describes configuring
host server management actions in the Oracle ILOM Administrator's Guide for Configuration
and Maintenance for your server's version of the Oracle ILOM firmware at
oracle.com/goto/ilom/docs.
Related Information
"POST Overview" on page 52
■
"Configure POST" on page 53
■
Verify That a Fault Has Been Cleared
1. After a faulted component is replaced and power is restored to the server or
component, check the server LEDs.
Verify that the OK and AC Present LEDs are lit, and that the Fault LED and front and rear
Service Required LEDs are not lit.
54 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
error_level = max
error_verbosity = max
hw_change_level = max
hw_change_verbosity = max
cd
set
show
Setting the verbosity values to max can cause POST to take more time to complete its
http://www.