Oracle SPARC M8 Service Manual page 135

This protects the arms from damage when you pull the component out.
9. Carefully remove the component from the SP tray, using two hands, and avoid
bumping the rear connectors.
Place the SP on a grounded antistatic mat.
10.
11.
Set the /System/DCUs failover property back to auto.
On an SP, type:
-> set /System/DCUs failover=auto
12. Determine your next step:
To replace the battery, see
■
To install an SP, see
■
Related Information
"SP General Status LEDs" on page 120
■
"Install an SP or SPP" on page 136
■
"Servicing Batteries" on page
"Install an SP or SPP" on page
Remove an SP or SPP
247.
136.
Servicing SPs 135