Install a Power Module
2.
Use a T20 driver to tighten two captive screws on the top and bottom of the
power module to secure it to the chassis.
3.
Complete the following steps to reinstall components you removed to service
the power module:
a.
Reinstall all PDECBs.
See
b.
Reseat the power supplies.
See
Reinstall the SP tray and the SPs.
c.
See
d.
Reinstall the following components.
See
Return the server to operation.
4.
240
SPARC M8 and SPARC M7 Servers Service Manual • September 2017
"Servicing PDECBs" on page
"Servicing Power Supplies" on page
"Servicing SP Trays" on page 243
"Servicing CMIOUs" on page 83
199.
165.
and
"Servicing SPs" on page
or
"Servicing Switch Units" on page
117.
189.