Oracle SPARC M8 Service Manual page 138

Install an SP or SPP
Note -
that had been installed prior to the replacement of the SP or SPP.
Restore the configuration information.
8.
-> cd /SP/config
-> load -source uri target
where:
uri is tftp, ftp, sftp, scp, http, and https
■
target is the remote location where you stored the configuration information
■
For example:
-> load -source tftp://129.99.99.99/pathname
(SPARC M7 servers only) If
9.
these steps:
a.
Reinitialize TPM and reset the tpmadm failover command if it was previously
in use.
For information about initializing TPM using the Oracle ILOM interface to enable failover,
see
b. Restore the TPM data and keys that were backed up to the Standby SP on a
new SP you install.
For information about migrating or restoring TPM data and keys, see
and Attached Devices in Oracle Solaris
10. Verify that the fault has been cleared and the replaced component is operational.
See "Verify That a Fault Has Been Cleared" on page
11. Verify that the SP date is correct.
-> show /SP/clock
/SP/clock
Properties:
->
138 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
You can load any supported system firmware version, including the firmware revision
Securing Systems and Attached Devices in Oracle Solaris
datetime = Tue Sep 07 08:09:59 2013
timezone = GMT (GMT)
uptime = 0 days, 00:01:18
usentpserver = disabled
TPM was initialized on the replaced SP, complete
11.3.
54.
11.3.
Securing Systems