Oracle SPARC M8 Service Manual page 131

This command can take several minutes to complete.
5. (Oracle ILOM 3.2.x only) Verify that the SPP is ready to remove by verifying that
its SPMs have stopped.
It can take up to two minutes for the SPMs to go offline. Once they are offline, you can prepare
the SPP for removal.
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_0 health
Properties:
health = Offline
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_1 health
Properties:
health = Offline
(Oracle ILOM 3.2.x only) After ensuring that the SPM has been taken offline,
6.
wait a couple of minutes and then verify that the PCIe devices have been taken
offline.
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2/Service_Processor_Module_0 state_pcie
Properties:
state_pcie = Offline
If state_pcie returns a value of Online, log onto the host and take the card offline for the
appropriate SP/SPM slot. See
M7-16)" on page 125.
Prepare the SPP for removal.
7.
-> set /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2 action=prepare_to_remove
This command powers off the SPP and turns on the blue Ready to Remove LED on the SPP.
Verify that the SPP is ready for removal.
8.
-> show /System/Other_Removable_Devices/Proxy_Service_Processors/
Proxy_Service_Processor_2 health
Properties:
health = Offline
Related Information
"SP General Status LEDs" on page 120
■
"Change Which SPP Is Managing DCU Activity (SPARC
Prepare to Remove an SPP (SPARC M7-16)
Servicing SPs 131