Downlink Software; System Requirements (Personal Computer); Installing Downlink Software; Downlink Software Practices - ABB STT04 Instruction Manual

INSTALLATION

DOWNLINK SOFTWARE

Download firmware
upgrades to the STT04
Upload and download
configurations on a PC

System Requirements (Personal Computer)

Installing DownLink Software

DownLink Software Practices

WARNING
DOWNLINK SOFTWARE
3 - 4
The DownLink Software is a Windows
to interface the STT04 terminal with a personal computer. The Down-
Link Software provides the STT04 terminal with the ability to:
When enhancements are made to the STT04 firmware, users can
access the latest revision via the internet and then download it to the
STT04 terminal from a personal computer.
Configurations can be saved from the STT04 terminal to a personal
computer for storage where they can be retrieved when needed.
Before attempting to install the DownLink Software on a personal
computer, be sure the PC has at least the minimum requirements
listed in Table 3-1.
Table 3-1. System Requirements
System Attribute
Processor
Hard disk space
Operating system and RAM memory
Windows 95

Windows NT 4.0 or greater
1. Insert the CD.
2. Click Start and select Run.
3. Click in Open and type CD Drive letter:\setup and click OK.
4. Follow the installation prompts as they appear.
When using the DownLink Software application, it is important
to name each STT04 terminal that will be used with a particular
personal computer. This is important to avoid database prob-
lems. Each STT04 terminal should have it's own database that
will carry a name linking it to the corresponding STT04
terminal.

-based application that is used
Requirements
Minimum Recommended
®
486-based Pentium -based
8 Mb 16 Mb
16 Mb 32 Mb
16 Mb 32 Mb