ABB STT04 Instruction Manual page 245

Key Display
MESSAGE:
E N TE R
←PREVIOUS
DESCRIPTOR:
E N TE R
←PREVIOUS
DATE:
DAY: nn
E N TE R
MONTH: nn
YEAR: nn
OUTPUT TYPE
→ LINEAR
E N TE R
SQUARE ROOT
FUNC GENERATOR
3/2 FLOW MODE
DAMPING:
(0 - 60 SEC)
E N TE R
0.5 SECS
ENGINEERING UNIT
→
iH20
E N TE R
ftH2O
mmHg
LOWER RANGE VAL
nn.nn UNITS
E N TE R
UPPER RANGE VAL
nn.nn UNITS
Type a descriptive message using up to 32 charac-
ters. This field can be used to note anything of impor-
tance to the device or installation.
NEXT→
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.
Type a descriptor string using up to 16 characters.
This field can be used for notations about the device
or process.
NEXT→
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.
Enter a day and press
press
ENTER
This date can represent the creation date of the con-
figuration, the date the device or element was
installed, or some other significant date.
Select LINEAR.
NOTE: Other output type selections are SQUARE
ROOT, FUNC GENERATOR and 3/2 FLOW MODE.
NOTE: IBIS software is needed to configure FUNC
GENERATOR breakpoints.
Use
BACK
screen from any screen in the configuration process.
Enter a value between 0 and 60 seconds.
Select an engineering unit best suited for the
application. Other units not shown include BARS,
iHg
mBAR, gSqCm, KgCm2, Pa, KPa, torr and ATM.
mmH2O
PSI
Input lower range value using the arrow keys, then
press
ENTER
press
ENTER
AS800 PRESSURE TRANSMITTER
Comments
. Enter a month and
ENTER
. Enter a year and press
to return to a previous configuration
. Input the upper range value, then
.
CREATE/MODIFY CONFIGURATION
.
ENTER
P - 3