ABB STT04 Instruction Manual page 125

Key Display
ENGINEERING UNIT
iH20cmH2OmmHg
→
E N TE R
PSIMPAKPA
BARSmBARKgcm2
LOWER RANGE VAL.
nn.nn UNITS
E N TE R
UPPER RANGE VAL.
nn.nn UNITS
INITIALIZE MODE:
→ LOW
E N TE R
HIGH
FAIL MODE:
→ LOW
E N TE R
HIGH
LAST
ENTER
SECONDARY UNITS
E N TE R
_nnnnnn
SECONDARY L. R.
nn.nn UNITS
E N TE R
SECONDARY U. R.
nn.nn UNITS
LOWER TEMP ALARM
-40.00°C
E N TE R
UPPER TEMP ALARM
85.00°C
PTS PRESSURE TRANSMITTER
Comments
Select an engineering unit best suited for the
application.
Input lower range value using the arrow keys, then
press . Input the upper range value.
ENTER
Refer to the Platinum Standard Series Smart Pres-
sure Transmitter PTS instruction for mode descrip-
tion.
Make a selection using the arrow keys.
This is a 6-character alphanumeric designation to
represent values in user familiar units.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character. Press
when finished.
Specify values using the number keypad. The UNITS
displayed will be those designated in the previous
screen. After entering value press
Lower and upper temperature alarms are user con-
figured. The temperature is based on the cell. The
default alarms setting are shown here. The defaults
are also the lower and upper limits of the alarm.
NOTE: Use to return to a previous configura-
BACK
tion screen from any screen in the configuration pro-
cess.
CREATE/MODIFY CONFIGURATION
ENTER
.
ENTER
E - 3