Appendix H - Eqn Temperature Transmitter; Introduction; Create/Modify Configuration; Configuration Flowchart (Eqn - ABB STT04 Instruction Manual

APPENDIX H - EQN TEMPERATURE TRANSMITTER

INTRODUCTION

CREATE/MODIFY CONFIGURATION

SELECT
ABB FSK
DEVICE
TYPE
C
O
N
F
I
G
U
R
E
SELECT
LINEAR
OUTPUT
TYPE
FUNCTION
GENERATOR
ENTER 5
INPUT/OUTPUT
POINTS
This appendix covers the configuration and calibration functions of
the EQN Temperature Transmitter.
Refer to OPERATING PROCEDURES
the following functions:
Send configurations.
•
Get configurations.
•
View configurations.
•
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
A configuration can be created off-line, without a connected field
device. Refer to Figure
function. The following table details the configuration process.
SELECT ENTER
TRANSMITTER CONFIGURATION
TYPE ID TAG
SELECT ENTER
OUTPUT DAMPING
ACTION VALUE
ENTER
SECONDARY
UNITS
Figure H-1. Configuration Flowchart (EQN)
in Section 4 for information on
Select configurations.
•
Erase configurations.
•
Operational functions.
•
H-1 for an overview of the configuration
SELECT
THERMOCOUPLE
TYPE
T/C
SELECT
SELECT ANALOG
SENSOR
MODE
TYPE
mV
DIGITAL
ENTER
SELECT
CHANNEL
OHMS
NUMBER
SELECT
SELECT
NUMBER OF
mV
ELEMENTS
ENTER SELECT
LOWER/UPPER INITIALIZE
RANGE VALUES MODE
ENTER LOWER/UPPER
STORE
SECONDARY
CONFIGURATION
RANGE VALUES
SELECT
APPROXIMATION
METHOD
SELECT
RTD
RTD
TYPE
OHMS
SELECT
NUMBER OF
ELEMENTS
SELECT
ENGINEERING
UNITS
SELECT
FAIL
MODE
T01618A
INTRODUCTION
H - 1