Temperature Calibration - ABB STT04 Instruction Manual

AS800 PRESSURE TRANSMITTER
Key
APPLY 0 INPUT
TO SENSOR
E N TE R
THEN HIT ENTER
ID TAGNAME
E N TE R

Temperature Calibration

Key
OUTPUT WILL BE
AFFECTED! PROCEED?
C A LI-
B R ATE
→ YES
E N TE R
→ TEMP. CAL
ENTER SENSOR
E N TE R
TEMPERATURE
CALIBRATION
P - 10
Display
READY
Display
NO
INPUT A/D CAL
D-TO-A ADJUST
ZERO TRIM
Comments
Apply zero value to the transmitter.
ZERO TRIM is complete.
Comments
This operation will cause a change in output not cor-
responding to the input. Be sure the control loop is in
manual.
Select YES.
Select TEMP. CAL.
If digitally configured, the D-TO-A ADJUST selection
will not appear.
Enter TEMPERATURE value,
ENTER .