Initial Start-Up - ABB STT04 Instruction Manual

Key
S PE C IA L
FE ATU R E
C L E AR
S EL E C T
D E V IC E
V IE W
O P T IO N S
B A C K

INITIAL START-UP

Key
O N
COMMUNICATION FORMAT
→ ABB FSK
E N TE R
HART
Table 4-1. Keypad Functions
1. Sets output to a fixed value.
2. Cancels a fixed output.
3. Sets up LCD - select display units to be displayed on the field device LCD.
4. Changes device configuration to the standard configuration (PTS only).
NOTE: For special feature functions refer to the appropriate Appendix.
Escapes the current function and returns the display to the READY condition.
Selects and changes working configurations and field devices (if connected).
Steps through the selections of the working configuration. Views a configura-
tion, but does not allow modifications to be made.
1. Sets the language of the display screens.
2. Sets the communication format.
3. Displays the amount of charge left on the battery pack.
4. Displays the STT04 name.
Returns to a previous screen during configuration, calibration, rerange, etc.
The sequence of screens described will appear when the STT04 ter-
minal is powered up for the first time and is not connected to a field
device, or when a configuration is created and stored in the terminal.
NOTE: The terminal (if not configuring or calibrating) will automati-
cally shut itself off after approximately 15 minutes without operator
interaction.
Display
ABB
STT04
REVISION nn.n
OPERATING PROCEDURES
(continued)
Function
Comments
Displays the firmware revision of the STT04 terminal.
STT04 terminal prompts for a communication format.
Select a communication format using the up or down
key. After selecting communications, the terminal
scans for devices of the selected format. Select the
correct communication format.
INITIAL START-UP
4 - 3