Using Downlink Software - ABB STT04 Instruction Manual

USING DOWNLINK SOFTWARE

Main Menu
Selections
Functions
Database New
Open
Exit
View Connected STT04
Configurations
Database files
Transfer Upload from STT04
Configurations
Download to STT04
Utilities Test Communication
Change STT04 name
Special Report diagnostics
Advanced
Upgrade firmware
Upgrade boot code
Set COM port
2. Insert the Password Key disk into the appropriate floppy disk
drive.
3. Click Key and type the appropriate floppy disk drive letter (i.e., A:)
and click Verify. The screen shown in Figure
4. Click View and a list of user names appears.
5. Click Cancel when finished.
6. Remove the Password Key disk and store in a safe and secure
location. Only Supervisor security level personnel should have
access to the Password Key disk.
This section provides steps for each menu function of DownLink soft-
ware. Table O-2 summarizes the software functions.
Table O-2. Software Function Summary
Creates a new database folder on the PC.
Opens an existing database folder and it becomes the current data-
base.
Closes the application.
Shows a list of configurations in the connected STT04.
Shows a list of configuration files in the current database.
Transfers configuration files from a connected STT04 to a database
file folder on the PC.
Copies configurations files from a PC database folder to a con-
nected STT04.
Tests communications connection between the PC and the con-
nected STT04.
Changes the name of the connected STT04 terminal.
Reports general information about the connected STT04.
Upgrades firmware of the STT04.
Use this only when instructed by ABB technical support.
Use to select the communication port on the PC that will be used to
interface an STT04.
STT04 DOWNLINK SOFTWARE
O-1 appears.
Descriptions
USING DOWNLINK SOFTWARE
O - 5